| 1. | Calibration factor of the primary device
一次装置的校准系数 |
| 2. | Calibration factor of a data channel
数据通道校正系数 |
| 3. | Main component self - compare with calibration factor can be used when testing impurity content
测定杂质含量时，可采用加校正因子的主成分自身对照法。 |
| 4. | Main component self - compare without calibration factor can also be used when there is no impurity reference substance
当没有杂质对照品时，也可采用不加校正因子的主成分自身对照法。 |
| 5. | This calibration factor can be directly recorded under each type for calibrating actual measured peak area of impurities
此校正因子可直接载人各品种项下，用于校正杂质的实测峰面积。 |
| 6. | There are three mathematical models of multi - spectral thermometry based on calibration factor , brightness temperature and reference temperature respectively
多光谱辐射测温法的数学模型有基于检定常数的数学模型、基于亮度温度的数学模型和基于参考温度的数学模型。 |
| 7. | You can also formulate corresponding 80 % , 100 % and 120 % of reference substance solutions according to tested items of calibration factors of each type , plus specified amount of internal standard solution to make 3 different density solutions , blend samples for continuous 3 times , and calculate calibration factor
也可按各品种校正因子测定项下，配制相当于80 % 、 100 %和120 %的对照品溶液，加入规定量的内标溶液，配成3种不同浓度的溶液，分别迸样3次，计算平均校正因子。 |
| 8. | When establishing the method , according to stipulations under each type , precisely weigh ( measure ) appropriate amount of impurity reference and component reference under test to formulate solutions testing impurity calibration factor , blend samples and record chromatograph chart , calculate calibration factor of impurity according to above mentioned method ( 1 )
在建立方法时，按各品种项下的规定，精密称(量)取杂质对照品和待测成分对照品各适量，配制测定杂质校正因子的溶液，迸样，记录色谱图，按上述( 1 )法计算杂质的校正因子。 |
